If you have concrete grates in your swine barn that are wearing out and would like to coat, treat or replace them, consider installing our PE plastic plates with studs or tear sheets on them. This will give your concrete slats a protective layer and thus a new life. You will save a lot of money and time compared to new slats or coating them. The new plastic protective plates on your concrete grids keep bacteria and germs at bay and optimize hygiene in the barn. The plastic grating plates are completely liquid-proof, mechanically loadable and easy to clean. Of course, it is important that your concrete slats still have enough load-bearing capacity to support the pigs. These plastic sheets cannot take over the carrying capacity of the concrete grates, but they do give your grates a smooth and hygienic surface again and prevent further wear of your concrete grates. We offer the plastic tear plates in 9mm thickness and 12mm thickness. We recommend 9mm thick guards for piglets and 12mm thickness for finishing pigs.
Manure slits milled in at the factory
We can factory mill our PE sheets, which are standard in our warehouse with a size of 3000×1500, to size and also equipped with slits for good manure passage. You can specify the slit width of the grate protectors by means of a drawing. The angle of the milled manure slot is square and smooth, but we can round off/burr this angle on our milling table if you wish.
The plastic concrete grating protection plates can be mounted in different ways. You can fix them yourself with plugs, screws and body washers in the existing grate. We also produce our own stainless steel grate anchors that you can insert, turn and tighten through the manure gap of your existing concrete grates. We have from our own production stainless steel grate anchors with 50mm stainless steel thread, 120mm thread and 150mm thread and stainless steel M10 thread with which you can fasten the plastic grate anchors.